The car shock absorber is connected between the wheel chassis and the body frame, which can absorb the vibration of the vehicle when the vehicle is bumped, and can also play a stabilizing role when the car is cornering. Oil leakage of the car shock absorber means that it is damaged, and the damping effect will gradually decrease. After a long time, the shock absorber will lose its damping effect when the oil in the shock absorber leaks. Therefore, it is necessary to replace the oil leakage of the car shock absorber. And need to be replaced in time.
Although the car's shock absorber can continue to drive with oil leakage, abnormal noise may occur, and the buffer capacity of the shock absorber will decrease. When passing through some potholes, the body is prone to bumps and affects driving comfort. Moreover, if the vehicle speed is too fast, the body may fluctuate up and down, reducing the stability of the car.
It is necessary to replace the oil leakage of the automobile shock absorber. When it is found that the automobile shock absorber has oil leakage, check whether the cylinder head screw nut is tightened. It should be replaced with a new one; if the problem still cannot be solved, pull out the shock absorber rod. If there is a pinch or difference in weight, check whether the gap between the piston and the cylinder is too large, and whether the shock absorber piston connecting rod is bent Whether there are scratches or pull marks on the surface of the piston connecting rod and the cylinder tube, repair and replace new parts according to the situation.
When the shock absorber is found to have abnormal noise, excessive hardness, damage to the rubber pad, falling off, deformation of the dust tube, oil leakage, etc., it must be replaced. If the car brakes urgently when driving slowly, the vibration is more severe, indicating There is a problem with the shock absorber and needs to be checked and replaced. The shock absorber is a very important component. When replacing the shock absorber, it must be replaced on both sides, not just one side, so as to ensure that the shock absorbers on both sides have the same properties.