Toyota Corolla rear shock absorber replacement method, the rear shock absorber as an example:
The tools you need to prepare are as follows: the original car wheel socket, jack, hook for removing the tyre cover, 16mm socket with bent rod, 16mm open-end wrench or box wrench or adjustable wrench, 5mm open-end wrench, straight-out tool.Then began to replace the shock absorber.
Park the car on a flat ground and pull on the handbrake, put it in a gear, and use a small hook to remove the tire cover. Use the original car to remove the wheel sleeve to loosen the fixing bolt, use the jack to jack up the rear wheel, remove the wheel and The wheels are placed under the body to ensure safety.
Use a 16mm socket with a bent rod and a 16mm open-end wrench to remove the lower fixed point of the shock absorber. Use a 16mm sleeve with a bent rod to remove the fixed point of the viewer. The wheel sleeve can be used as an afterburner. If the screw is too tight because of rust, you can spray a little anti-rust agent before loosening it. Then you can remove the shock absorber.
When replacing a new shock absorber, compress the shock absorber properly, install the fixing bolts first, and then stretch the shock absorber to the two fixing bolts at the installation point. Note that the upper and lower installation points must be tightened with more force.